It sounds like you've covered nearly all the important applications to RC boats. We have been working with a number of RC Sailboat racing enthusiasts over the years, and all of them rave about the benefits of using Sailkote.
We are lucky enough to hear back from many of the top competitors quite often,
and there are a couple of thoughts that I'd like to add to the
information you have already discussed;
A) For best results on plastic parts, please be sure to only apply an
ultra-thin coating to the hull, deck, sails, mast, rudder posts, adjustment
sheets and lines, and all other parts, both moving and non-moving.
According to the experts, they prefer to apply Sailkote out of the
spray can and lightly "mist" the entire boat from top to bottom,
although the product can also be "wiped on". Either way, allow
to dry completely and then after a few minutes, gently buff hull with a soft
cloth for best (fastest) finish.
B) For the sheets, control lines, and other adjustment ropes onboard, you can
either dip and wipe off excess Sailkote with a cloth, or you can apply onto
tough to reach areas with cotton swab.
C) Be sure to avoid over applying or "puddling" the product onto any soft plastics as this kind of severe over application can be harmful due to the solvent carrier and propellant that are designed to dry immediately on contact in order to help the active (slippery) ingredient properly adhere to the parts. Basically, be careful not to over apply, as a thin coat is the best coat.
I hope these comments help, and thanks for your interest in Sailkote.
Sincerely,
Ron Rosenberg
